Mindblown: a blog about philosophy.

  • Vyapam Sub Engineer Mechanical Paper 9th July 2017 Second Shift

    Madhya Pradesh Vyapam Sub Engineer Mechanical Paper 9th July 2017 Second Shift The value of stress corresponding to force on whose removal deformation disappears is known as ___________ (a) Fracture (b) Proportionality limit (c) yield point (d) Elastic limit Ans – (d) The pitch of lead screw is 5 mm and pitchof thread to be…

  • Vyapam Sub Engineer Mechanical Paper 9th July 2017 Shift I

    Madhya Pradesh  Vyapam Sub Engineer Mechanical Paper 9th July 2017 Shift I A load cell is essentially a _______ (a) thermistor (b) resistive potentiometer (c) inductive transducer (d) strain gauge Ans – (d) Mapping of geometric models include __________ (a) Translatinal mapping only (b) Rotatinal mapping only (c) Both translational mapping and Rotational mapping (d)…

  • Vyapam Sub Engineer Mechanical Paper 8th July 2017 Second Shift

    Madhya Pradesh Vyapam Sub Engineer Mechanical Paper 8th July 2017 Second Shift If mass is entering and leaving an open system then the process is said to be _____________ (a) non flow process (b) non adiabatic process (c) flow process (d) adiabatic process Ans – (c) A pressure measurement instrument is calibrated between 10 bar…

  • Madhya Pradesh Vyapam Sub Engineer Interior Design Paper 8th July 2017 Shift I

    Vyapam Sub Engineer Interior Design Paper 8th July 2017 Shift I A low or partial floor between two main floors of a building is called _________ (a) mezzanine floor (b) cellar (c) attic floor (d) half story Ans- (a) A stone edging to a pavement or raised path is knwon as __________ (a) Framing (b)…

  • Vyapam Sub Engineer Electrical and Electornics Paper 8th July 2017 Shift I

    Vyapam Sub Engineer Electrical and Electornics Paper 8th July 2017 Shift I In a GTO, anode current begins to fall when gate current __________ (a) is negative peak at time t=0 (b) is negative peak at t=storage period ts (c) is negative peak at t=(ts+fall time) (d) just begins to become negative at t=0 Ans-…

  • Vyapam Sub Engineer Civil Paper 9th July 2017 Second Shift

    Madhya Pradesh Vyapam Sub Engineer Civil Paper 9th July 2017 Second Shift Gunter’s chain is also known as __________ (a) Band chain (b) Engineer’s chain (c) Surveyor’s chain (d) Revenue chain Ans – (c) ‘Vee-Bee’ consistometer is used to find ________of concrete. (a) permeability (b) flexural behavior (c) compressive strength (d) workability Ans – (d)…

  • Madhya Pradesh Vyapam Sub Engineer Civil Paper 8th July 2017 Second Shift

    Vyapam Sub Engineer Civil Paper 8th July 2017 Second Shift Surveyor compass works on the principle of (a) Magnetic bearing system (b) Whole circle bearing system (c) Quadrilateral bearing system (d) None of the above Ans – (c) An estimate which is prepared on the basis of any of the approximate methods e.g, plinth area…

  • Madhya Pradesh Vyapam Sub Engineer Architecture Engineering Paper 2017

    Vyapam Sub Engineer Architecture Engineering Paper 9th July 2017 Second Shift Primary colours of natural light are (a) Red, Green, Yellow (b) Red, Blue, Yellow (c) Red, Violet, Yellow (d) Red, Blue, Green Ans – (b) HVAC in building systems stands for ________ (a) Heat Ventilation and Air Conditioning (b) High Voltage Air Conditioning (c) High…

  • Vyapam Sub Engineer Agriculture Engineering Paper 2017

    Vyapam Sub Engineer Agricultural Engineering Paper 8th July 2017 Shift I If clearance volume of a 10×12 cm CI engine is 62.85 cubic cm, its compression ratio is ___ (a) 16 : 1 (b) 20 : 1 (c) 8 : 1 (d) 12 : 1 Ans- (a) In adiabatic process ______in the system (a) heat…

  • Odisha PSC Assistant Engineer Electrical Paper 2012-13

    Odisha Public Service Commission Assistant Engineer Electrical Paper 2012-13 In a series RLC circuit, the rms value of voltage across the resistor is 30V, across the inductor is 60V and across the capacitor is 20 V. The rms supply voltage would be (a) 110 V (b) 010 V (c) 220 V (d) 050 V Production…

Got any book recommendations?