Objective Questions on Digital Circuits and Microprocessors

Solapur University MCA (Semester-I) Paper on Digital Circuits and Microprocessors March 2019

 

Sr. No. Question
1 In which of the following gates, the output is 1, if and only if at least one input is 1?

(a)    NOT

(b)   AND

(c)    OR

(d)   NAND

2 Which table shows the logical state of a digital circuit output for every possible combination of logical states in the inputs?

(a)    Function table

(b)   Truth table

(c)    Routing table

(d)   ASCII table

3 How many lines the truth table for a four-did not input NOR gate would contain to cover all possible input combinations?

(a)    4

(b)   8

(c)    12

(d)   16

4 The function of a multiplexer is __________

(a)    To decode information

(b)   To select 1 out of N input data sources and to transmit it to single channel

(c)    To transmit data on N lines

(d)   To perform serial to parallel conversion

5 Which is the correct sequential order of operational steps executed in the combinational logic circuits?

1.       Operation of combinational gates over the inputs

2.       Acceptance of n-different inputs

3.       Generation of ‘m’ different outputs as per the required level

(a)    A,B,C

(b)   A,C,B

(c)    B,A,C

(d)   C,A,B

   
6 What does the below stated Boolean Law imply, while performing below stated operation of an input with ‘0’?

Expression of Law : A.0 = 0

(a)    Output will always be equal to input

(b)   Output will always be high

(c)    Output will always be low

(d)   Output will always be same

7 Which digital system translates coded characters into a more intelligible form?

(a)    Encoder

(b)   Display

(c)    Decoder

(d)   Counter

8 The binary number 10101 is equivalent to decimal number _______

(a)    19

(b)   12

(c)    27

(d)   21

9 The output of a half adder is _________

(a)    Sum

(b)   Sum and Carry

(c)    Carry

(d)   None of these

10 1’s complement of 00011001 is _______

(a)    11100110

(b)   00011001

(c)    11001111

(d)   00110110

   
11 In 8085 microprocessor, RD pin this is used for _______operation. It is an output signal. It is active when low.

(a)    Ready

(b)   Remove directory

(c)    Reset

(d)   Read

12 _________is an edge triggered input which results in a type II interrupt.

(a)    New maskable interrupt

(b)   Non maskable interpole

(c)    Non maskable interrupt

(d)   New maskable interjector

13 The ALE signal, when the pulse goes high, it indicates address. When the pulse goes down it indicates _______

(a)    Data

(b)   Read

(c)    Write

(d)   Fetch

 14 The MOV instruction copies the contents of the source register into the _______ register without any alteration.

(a)    Data

(b)   Segment

(c)    Offset

(d)   Destination

   
  Published on 6th Oct 2021
   

 


Posted

in

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *