Karnataka Motor Vehicle Inspector Previous Year Paper Section C

Karnataka PSC Motor Vehicle Inspector Paper Section C

 

Sr. No. Question
1 A friction clutch works on _______

(a)    Principle of friction

(b)   Fluid flow

(c)    Principle of kinetic energy

(d)   Power transmission methods

2 The main function of spring is _________

(a)    To damp out vibrations

(b)   To damp the road shocks

(c)    The fluid is intendant to damp vibrations

(d)   To stabilize the cars

3 Which one of the following is not a source of emission (pollutant) from a vehicle ____

(a)    Crank case emission

(b)   Evaporative losses

(c)    Exhaust emission

(d)   Fuel burning

4 The system to lower the peak combustion temperature to minimize the formation of NOx (Controlling of exhaust emission) is ____________

(a)    Thermal Reactor

(b)   Catalytic converter

(c)    Electronic spark control system

(d)   Exhaust Gas Re-circulation (EGR)

5 Age limit in connection with driving of motor vehicle is ______

(a)    Above 18 years

(b)   Below 18 years

(c)    Between 18 to 21 years

(d)   Above 15 years

   
6 Extent of effectiveness of learner, licences to drive motor vehicle has to be in _________

(a)    Karnataka State

(b)   Throughout India

(c)    Area of R.T.O jurisdiction

(d)   In the city where the licences are issued

7 Inspection of Vehicle involved in accident is done by a _____

(a)    Any person authorized in this behalf by a State Government

(b)   Any person authorized in this behalf by a Central Government

(c)    Any person authorized in this behalf by a Court

(d)   Any Police Person

8 Petrol that detonates easily is called as _______

(a)    High octane petrol

(b)   Low octane petrol

(c)    Blended petrol

(d)   Unleaded petrol

9 The characteristic that is enhanced by honing of cylinder sleeve liner of an IC engine is ____________

(a)    Lubrication performance

(b)   Cooling efficiency

(c)    Wear resistance

(d)   None of the above

10 Instrument used in checking specific gravity of the acid in battery is ________

(a)    Hygrometer

(b)   Hydrometer

(c)    Multimeter

(d)   Anemometer

   
11 A typical crank shaft of an in the line four cylinder engine has _________

(a)    16 balance weights

(b)   12 balance weights

(c)    8 balance weights

(d)   4 balance weights

12 The clutch is located between the gear box transmission and ________

(a)    Rear axle

(b)   Propler shaft

(c)    Engine

(d)   Differential

13 The Characteristic of brake fluid is _________

(a)    High boiling point

(b)   Low velocity

(c)    Compatible with rubber

(d)   All of the above

14 The front stabilizer bar is used in automobiles to ________

(a)    Increase Load Capacity

(b)   Safer ride

(c)    To control suspension and body roll

(d)   None of the above

15 The commonly used antifreeze solution in automobile is ________

(a)    Ammonium Chloride

(b)   Freon – 12

(c)    Ethyl glycol

(d)   Carbon di sulphide

   

Posted

in

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *