ISRO Propulsion Complex means IPRC will be conducted the recruitment exam for the post of Technician Fitter on 10th April 2022. If you had already applied for the said IPRC Vacancy post and searching IPRC Technician Fitter Previous year Paper for preparation as per ISRO IPRC Technician Fitter Syllabus, then our team is providing the ISRO Propulsion Complex Technician Fitter last year papers in this article, which is helpful to you crack the ISRO exam 2022.
ISRO Propulsion Complex Mahendragiri Fitter Paper 2016
Date of Exam – 28th Aug 2016
Duration of Exam – 1 Hour 30 Minutes
No. of questions – 60 Nos.
Current is measured by an instrument called
(a) Voltmeter
(b) Resistor
(c) Capacitor
(d) Ammeter
A magnetic compass always points
(a) East
(b) West
(c) North
(d) South
Density of water is
(a) 10,000 kg per cubic meter
(b) 1000 kg per cubic meter
(c) 100 kg per cubic meter
(d) 1 kg per cubic meter
Symbol for Gold is
(a) Age
(b) Ar
(c) Al
(d) Au
_____ is used for galvanising iron to protect it from rusting
(a) Calcium
(b) Aluminium
(c) Copper
(d) Zinc
Solder is an alloy of
(a) Copper and nickel
(b) Chromium and Nickel
(c) Copper and Zinc
(d) Lead and Tin
Hardest natural substance known is
(a) Granite
(b) Marble
(c) Dimond
(d) Graphite
Melting point of Aluminium is approximately
(a) 1000 degree Celsius
(b) 500 degree Celsius
(c) 1500 degree Celsius
(d) 660 degree Celsius
One inch is equal to
(a) 24.5 mm
(b) 25.4 mm
(c) 25.2 mm
(d) 24.4 mm
Gauge used for measuring small air gaps and clearances
(a) Ring gauge
(b) Feeler gauge
(c) Taper gauge
(d) No Go gauge
Try-square is used to measure
(a) Angle between surfaces
(b) Check squarness of the surfaces
(c) Straightness of surfaces
(d) None of the above
Number of threads per inch in a screw or bolt is checked by
(a) Vernier Calliper
(b) Dial gauge
(c) Screw pitch gauge
(d) Thread plug gauge
Sine bar is used to measure
(a) Angle of a tapered job
(b) Angle between surfaces
(c) Run out of job
(d) None of the above
Purpose of hollow punch is
(a) Deepen a drill point
(b) Making the marked lines firm
(c) Determining the centre of a round job
(d) For making holes in thin metallic, leather or hard board sheets
In a metric vernier calliper 49 main scale divisions are divided in to 50 vernier scale divisions. So least count is
(a) 0.01 mm
(b) 0.2 mm
(c) 0.02 mm
(d) None of the above
Leave a Reply