DSSSB Motor Vehicle Inspector Paper 2014

यदि आप DSSSB Delhi द्वारा आयोजित मोटर व्हीकल इंस्पेक्टर (Motor Vehicle Inspector ) एग्जाम 2022 में appear होने जा रहे हो तो आपको DSSSB Motor Vehicle Inspector Previous Year Question Paper को refer करना चाहिए। ताकि आपको DSSSB Motor Vehicle Inspector Exam Pattern की जानकारी हो सके और आप उस अनुसार परीक्षा की तैयारी कर सके। इसलिए हमारी टीम ने यहाँ DSSSB Motor Vehicle Inspector Exam का पिछले वर्षों में से एक पेपर आपके लिए प्रस्तुत किया है।

DSSSB Motor Vehicle Inspector Paper 2014

What term is used to describe the type of lubrication given to an engine piston ?
(a) boundary
(b) pressure
(c) pumped
(d) full-film

Most motor cars use a specially constructed body shell onto which is attached the main components. The construction is called
(a) channel
(b) integral
(c) separate
(d) indepandent

A frame consisting of side and cross members of channel section is normally used on
(a) light cars
(b) motor cycles
(c) heavy motor cars
(d) heavy commercial vehicles

For a spark plug M 14 x 1.25 the last figure 1.25 stands for
(a) electrode diameter in mm
(b) tip width in mm
(c) gap between electrodes in mm
(d) pitch of plug thread

When considerable material must be removed to clean up a cylinder bore, the cylinder should be
(a) bored
(b) honed
(c) reamed
(d) glazed

Exhaust gas leakage into the cooling system is mot likely to be due to defective
(a) cylinder head gasket
(b) manifold gasket
(c) water pump
(d) radiator

Balls for a ball bearing are made of
(a) stainless steel
(b) carbon chrome steel
(c) mild steel
(d) high speed steel

Type of bearing used in wheel hub
(a) ball bearing
(b) roller bearng
(c) taper roller bearing
(d) needle bearing

Wheel base of a vehicle is the
(a) distance between fron and rear axles
(b) distance between the front typres
(c) width of tyres
(d) the combined width of rear tyres

In a diesel engine the duration between the time of injection and time of ignitiion is called
(a) spill cutoff
(b) delay peirod
(c) period of injection
(d) period of ignition

The valve is opended as the cam lobe on the carn raises the
(a) valve lifter
(b) bearing
(c) piston pin
(d) valve guide

The escape of burned gases from the combustion chamber past the pistons and into the crank case is called
(a) gas loss
(b) blow-by
(c) by-pass
(d) crank case explosion

In a diesel engine the function of a fuel injector is
(a) to mix fuel and air
(b) to ingite air-fuel mixture
(c) to provide flame front of ingition
(d) to spary atomized fuel in the cylinder

The inertia of the rotating parts of the clutch should be
(a) minimum
(b) maximum
(c) zero
(d) medium

Universal joint is used to connect two shafts
(a) at angle
(b) in parallel
(c) in series
(d) in straight line


Posted

in

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *