Bihar SBTE Diploma CSE 4 Sem May 2019 DEM Paper

Bihar SBTE Polytechnic Diploma Computer Science & Engineering 4 Sem May 2019 DEM Paper

 

Sr. No. Questions with options
1 Which of the following is minimum error  code?

(a)    Octal code

(b)   Gray code

(c)    Binary code

(d)   Excess-3 code

2 A NOT gate has

(a)    Two input and one output

(b)   One input and one output

(c)    One input and two outputs

(d)   None of these

3 A set of instructions written in computer language is called the

(a)    Software

(b)   Hardware

(c)    Program

(d)   None of these

4 1’s complement of 10101 is given by

(a)    01010

(b)   01011

(c)    10101

(d)   00100

5 The shift register is designed to shift data

(a)    Only to left changing the order of the bits

(b)   Only to right changing the order of the bits

(c)    Either left or right changing the order of the bits

(d)   Either left or right with out changing the order of the bits

6 The 8085 instruction RAL performs the following operations

(a)    Rotate the content of accumulator to the right

(b)   Rotate the content of accumulator to the left

(c)    Rotate the content of accumulator to right through carry

(d)   Rotate the content the accumulator to left through carry

7 Disc and drum are the

(a)    Hardware part of the computer

(b)   Software part

(c)    Firmware

(d)   None of these

8 Which of the following memories normally has highest storage capacity?

(a)    Magnetic disk

(b)   Magnetic tape

(c)    Semi conductor memory

(d)   Core memory

9 OP-AMPs can be used to amplify –

(a)    D.C input signal only

(b)   A.C input signal only

(c)    D.C as well as input signal

(d)   None of these

10 Number of interrupts of intel 8085 are

(a)    5

(b)   3

(c)    4

(d)   2

11 A program written in mnemonics is called

(a)    High level language program

(b)   Low level language program

(c)    Assembly language program

(d)   None of these

12 One of the methods used for A/D conversion is

(a)    R-2R ladder

(b)   Weighted binary resistors

(c)    Successive approximation

(d)   None of these

13 In a micro computer ____ is its heart.

(a)    Microprocessor

(b)   ALU

(c)    Control unit

(d)   None of these

14 An R-S flip flop cannot be used to design T-type flip flop as

(a)    R=0, S=1 is not permitted

(b)   R=0, S-0 is not permitted

(c)    R=1, S-0 is not permitted

(d)   R=S=1 is not permitted

15 Flip flop comes in the category of

(a)    2-bit storage device

(b)   1-bit storage device

(c)    Multi bit storage device

(d)   None of these

16 Extremely low power dissipation and low cost can be achieved in

(a)    MOS ICs

(b)   CMOS ICs

(c)    TTL ICs

(d)   ECL ICs

17 The 8085 instruction INR r comes in the category of

(a)    Machine control group

(b)   Branch group

(c)    Arithmetic group

(d)   Data transfer group

18 An ideal OP-AMP has

(a)    Infinite Av

(b)   Infinite Ri

(c)    Zero Ro

(d)   All of the above

  Data Collected By – K. Jeyanthi
  Published On – 21st April 2022
   
   

Posted

in

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *