Rajasthan Technical Education Second Year Paper 2016 Basic Automobile Engineering
In Maruti van following type of chassis is used
(a) Rigid control chassis
(b) Half forward control chassis
(c) Full forward control chassis
(d) None of the above
From the followings which element is NOT a part of Transmission system ?
(a) Clutch
(b) Tyre
(c) Gear box
(d) Rear axle
What is the use of master cylinder in Hydraulic Brake ?
(a) Increase pressure equally in wheel cylinder
(b) Decrease pressure equally in wheel cylinder
(c) Store the brake oil
(d) Increase the power of wheel cylinder
Material of Brake lining is
(a) Aluminium
(b) Copper
(c) Asbestos
(d) Iron
The Hand Brake usually operate on
(a) Front wheel
(b) Rear wheel
(c) Right side wheels
(d) All the wheels
Bleeding is done in Hydraulic Brake
(a) For removing brake oil
(b) For filling Brake oil
(c) For removing air
(d) For increasing pressure of brake oil
From followings the type of wheel which cannot be used with a tubeless tyre is ?
(a) Disc wheel
(b) Wire wheel
(c) Light alloy wheel
(d) Compostie wheel
Which type of wheel is used in Car ?
(a) Wire wheel
(b) Aluminium alloy wheel
(c) Disc wheel
(d) Magnesium alloy wheel
Which one of the following is NOT part of chassis ?
(a) Wheel
(b) Front Axle
(c) Differential
(d) Seat
The distance between the centres of front wheel is called
(a) Track
(b) Wheel base
(c) Axle width
(d) None of the above
The coefficient of friction for the clutch facing is approimately
(a) 0.4
(b) 0.8
(c) 1.0
(d) 0.2
Which element of transmission system is used to engage and disengage the engine and transmission shaft ?
(a) Grear box
(b) Clutch
(c) Front Axle
(d) Differential
Grear box is used in automobile for
(a) Changing speed
(b) Changing torque
(c) Reduction speed
(d) Increase power
For changing length of propeller shaft which joint is used ?
(a) Pin joint
(b) Universal joint
(c) Slip joint
(d) None of the above
Work of Universal joint in the transmission system is
(a) Change of length of propeller shaft
(b) Change of speed of propeller shaft
(c) Torque transmission at angle by propeller shaft
(d) All of the above
Leave a Reply